脚手架资料中英(8)

Appendix 2 附录2

AIR PRODUCTS AND CHEMICALS INC. 空气产品或化工有限公司

ROLLING TOWER SAFETY CHECKLIST 移动塔安全检查表

Work Request Number:工作申请号：

Area: 区域：

Date of Inspection: 检查日期： Inspector: 检查人： Working Load: 工作负荷： Pounds: 磅

Yes是 No否 Action/Comments措施/评论 1. Is the scaffold designed for the intended working load and posted?

脚手架被用于预期的工作负荷并悬挂标牌了吗？ 2. Is the scaffold height less than four (4) times the minimum base width?

脚手架的高度小于最小基础宽度的4倍吗？

3. Are scaffold components and planking in safe condition for use and is plank rated for scaffolds intended use?

脚手架组件和铺板处于安全的使用条件吗？脚手架铺板的额定负荷符合脚手架的拟定用途吗？

4. Have competent persons been in charge of erection?

始终由胜任人员负责安装吗？

5. Have screw jacks been used to level and plumb scaffold (maximum of 305mm (12\

用千斤顶螺钉校平并用铅锤检查移动脚手架的垂直度了吗？（最大高度305mm (12英寸)）

6. Are casters in firm contact with floor (ground working surface)?

小脚轮与层面（工作表面）紧密接触吗？

7 . Are casters of proper size with effective locking devices? (203mm (8\inches) casters minimum)

小脚轮的尺寸适合有效使用锁定装置吗？（小脚轮最小尺寸为203mm (8 英寸)）

8. Has horizontal diagonal bracing been positioned properly at the base and intermediate levels of 6.1m (20’ feet)? 在底层和中间层每隔6.1m (20英尺)安装了横向对角支撑了吗？

9. Are guardrails, mid-rails and toe boards in place on all open sides and ends above four 1.2m (4’ feet)?

1.2m (4英尺)以上的所有开放侧和开放端都安装了扶手、中间隔档和隔板了吗？

10. Have the brackets/load bearing fittings/coupler clamps/nuts and bolts been properly tightened? 托架/负荷承载配件/连接夹/螺母和螺栓都已正确紧固了吗？

11. Has proper access/fall protection been provided?

进入通道都已提供了摔落保护设备了吗？

12. Are Access ladders guarded or equipped to be used with fall arrest systems

进入梯都已安装了保护装置或者配备了防摔落保护装置了吗？

13. Have brackets and accessories been properly

installed:

托架和附件已经正确安装了： a. Brackets? 支架？

b. Tube and clamp? 管道和管夹？ c. All nuts and bolts tightened?

所有的螺母和螺栓紧固？

14. Is scaffold free of makeshift devices or ladders to increase height?

脚手架没有为了增加高度安装临时装置或梯子吗？ 15. Are working level platforms fully planked between

guardrails?

扶手之间的工作平台完全覆盖了铺板了吗？

16. Does wood planking extend a minimum of 152mm (6‖ inches) and a maximum of 305mm (12‖ inches) over end supports? 铺板向支架末端延伸部分最少为152mm (6英寸)、最多为305mm (12英寸)吗？

17. Does wood planking have cleats installed at end supports to prevent sliding?

木材铺板上在支架端部安装了防滑止挡了吗？ 18. Are planks secured to prevent displacement or

uplift?

为了防止位移或浮升，所有的铺板都固定了吗？ 19. Are toe boards installed securely for this type scaffold?

在这类脚手架上牢固地安装了隔板了吗？

20. Have you checked the method of hoisting poles and boards up the scaffolds?

Can the boards slip out and fall if a slip-knot fails? 你已核查过向脚手架上提升杆材和板材的方法了吗？如果接头发生故障，板材会滑落吗？

Is a support sack being used at the bottom of the load?

在负载的下方使用了支承袋了吗？ 21. Have hazardous conditions been provided for:

预防以下危险条件了吗： a. Power lines & grounding requirements ? 电力线和接地要求？

b. Un-level working surfaces? 上层工作面？ c. Possible wash-out of footings? 地脚可能被冲

刷？

d. Are casters properly installed? 正确的安装了小脚轮了吗？

22. If a tarpaulin/sheeting is secured to the scaffolding, has the scaffolding been designed to withstand the additional wind load?

如果脚手架上固定了帆布/铁 …… 此处隐藏：1387字，全部文档内容请下载后查看。喜欢就下载吧 ……