Color Laserjet 2600拆机指南

Yoda Teardown Overview

Service Part analysis

Yoda Teardown To remove the back

panel for access to the formatter and DC controller 9 screws to remove the back panel on the printer unit

Yoda Teardown The printer without

the back panel displays the– Formatter (4 screws, three cable connections – DC controller (4 screws, 16 cable connections)

Formatter removal Remove the power

connector Remove 9 screws from the back panel Remove 2 cables from the engine and 1 from the DC controller Remove 4 screws to lift the formatter out of the cage

DC Controller removal Disconnect the power

cable Remove 9 screws from the back panel Disconnect 15 separate connectors Remove 4 screws Take the PCA out of the printer

Control Panel removal Control Panel – Remove paper catch tray – Remove top cover trim – Remove top cover (4 screws) – Remove diverter (1 screw) – Remove control panel PCA (2 screws) and unplug 1 ribbon cable

Fuser removal Remove the power cable Open front door.

WARNING ! ETB is exposed and can be easily damaged. ETB is not a service part. Remove right side cover (1 screw) Remover paper output tray Remove top cover trim Remove top cover (4 screws) WARNING ! LV is now fully exposed ! Remove paper guides (3) Disconnect cables (6) WARNING ! Cable clasp is connected to LV board which is very brittle and easy to break Remove fuser (2 screws)

Separation Pad removal There are two screws

that need to be removed in order to change the separation pad

E-label reader removal It’s advised against

removing or replacing the E-label readers because of their proximity to the ETB